MB Lever Valve +Relief 1B DA Spool 3Pos
MB60 series of 1 to 6 bank monoblock mobile lever valve are designed for a maximum flow rate of 78 litres per minute with a maximum pressure of 250 bar on P A and B 40 on the tank port.
The lever pivots are fully sealed and the internal mechanism is greased for further protection against corrosion.
The spools are hard chromium plated to resist corrosion and wear.
The valves are suitable for use with mineral oil in the temperature range 0-80° C.
MB60 valves can be supplied in a wide range of configurations.
Close centre spools
3 position spring return
2 or 3 position detent
4 position spools with regenerative position.
Relief valves on A and B ports
Cross line reliefs on A and B ports
Pilot operated check valves on A and B ports
A wide range of centre configurations
Please contact our technical sales desk for assistance.
We are constantly adding products to this webshop. This is only a small selection of the products that we have available. If you don't see what you are looking for please do not hesitate to contact our experienced technical sales team on 01733 234800 or email us from the contact page on this website.Phoenix Hydraulics have a large range of log splitter hydraulics.
This valve is ideal for medium size log splitters for flow rates up to 78 litres per minute (17 gallons per minute) maximum pressure 250 Bar (3.600 psi)
With the lever in the centre position flow is diverted to tank at low pressure. Push the lever forward for the cylinder to extend. Pull the lever the cylinder will retract. When you let go of the lever it returns to its centre position. There is a relief valve built into the valve so that the maximum pressure can be set to protect your log splitter.
|Number of Spools||1|
|Max Flow||78 L/Min|
|A,B and P ports 1/2" T port 3/4"|
|Spool 1 closest to the relief valve||A & B ports blocked in centre Pressure to tank 3 position return to cent|